Started hacking into the cylinder last night. Took about an hour to get one transfer port semi-done.
And about a half hour to widen out the exhaust port. I plan on doing more work to the exhaust as I want to widen the port. I've been told I can go as wide as 25mm in the cylinder, but I need to measure where the edge of the ring travels in the cylinder.I also need more Dremel bits...
TIP: Make sure you stuff the cylinder with a rag while doing port work. There were a couple of times where my Dremel slipped and if I hadn't had the rag in place I would have gouged the inner wall of the cylinder.
No comments:
Post a Comment